Fondue Fun

Well hey there! Thanks for dropping by. You’re probably thinking that I have abandoned the blog, but no, I have just been out there living life and haven’t had a whole lot of time to write about it!

So, a couple of updates from last time. I FINALLY got around to changing the locks on the entry doors to the house, and adding dead bolts. I hate to say this so publicly, but the door and lock situations to this point have been pretty sad. The locks were not much better than something you would put on your bedroom door. Ok, maybe not, because they were actually keyed locks, but the upper and lower had different keys, I never did figure out which key was for the lower one, and they had no dead bolts. Bad news, right? I’d purchased new Weiser Smart Key lock sets way back in December – like, Cristmas week. I also purchased a template/guide tool and drill set that helps you know exactly were to put the holes in the doors. Honestly, the worst part was figuring out exactly where to drill the hole in the door frame for the deadbolt to bolt into. It took several tries. I also had a defective dead bolt for the floor downstairs. I tried and tried, and the screws would not screw it together. Finally I took it back to Rona and the guy figured out that the threads that the screws have to screw into, to hold it together, were damaged. Picked up a replacement and, voila, new locks, and the smart key system allowed me to rekey the new deadbolt for downstairs to the same key as upstairs. Easy!

The next and greatest update is on the progress of the kitchen. Jimmy brought help and he and his buddy Stu got my wall taken down, beam installed, etc. last week. I the got Rich, the electrician, to come back in Friday and he finished wiring up the kitchen, appliances, etc. and changed out the electrical panel. By 9pm Friday evening everything was working… and I had a disaster of a house to ready for a dinner party!!

I was up and working by about 8:30 Saturday morning, and by 5:30 when the first of my friends arrived, it felt like a home in here, for really the first time since I moved in. Here are a couple of photos.

IMAG1851

IMAG1850

Floor to Ceiling

Ok, so we’re making some good progress on the kitchen! On Friday, I took the day off work to help Jim out with the drywall. Turned out, he also borrowed a drywall hoist from a friend, and it was magic. Seriously, made life so much easier… just place the sheet of drywall on it, crank the wheel, and it held it to the ceiling while you screwed the thing to the rafters.
drywall_hoist

On Saturday, I grouted the tiles in the kitchen. Here’s the in progress shot:
grout

The colour of the grout was a tough choice… Jim was with me when I picked it out and we discussed a grey grout, and the one that I ended up choosing was called Bahama Beige… as you can see, it was really dark, like chocolate frosting, when it was wet, but when finished, it is a great colour match.

IMAG1780

Today, Jim did the drywall on the walls. Yay! It is finally starting to look like a proper room again!

IMAG1785

I can’t wait to have a kitchen again!!

Let’s Do Laundry!

Who knew that one day I would actually look forward to doing laundry! I never would have thought it was possible, but let me tell you… after going 2 months without having a dryer installed, the fact that I now have one working may not quite be reason to celebrate, but it is definitely exciting enough to want to do laundry! On Friday, Rich finished drilling the hole through the cinder block wall, and installing the plug, so that I could finally use my new dryer. I don’t know if I mentioned it previously, but the day after I moved in I had my new Samsung laundry pair delivered. They are High Efficiency, Super Capacity machines and this time, instead of buying the front load machines, I got the top load washer. so far, so good! Seriously though, I can not fathom a family spending all of their lives without proper laundry machines. It is so incredibly convenient to have a dryer, and to know that you can quickly get your clothes, bedding, etc. clean and dry without having them hanging all over the basement.

Anyway, aside from that, I have some progress to report on the kitchen… the tile is pretty much all in place, except where the wall will be coming down, and I think that Jim is coming tomorrow (possibly with a mutual friend, Mark, to help) to do the drywall. So exciting! Here is an in progress photo of the tiles.
IMAG1693
By next week, the cabinets should be in place so that I can order up the counter top, seeing as they’re going to take a few weeks to come in. In the meantime, Jim can finish up the other bits – like taking out the wall and putting in the beam.

Oh… my super fun purchase this weekend was these bar stools, which will sit at the island!
barstools

I think that’s it for now!

It’s almost a bathroom!

It’s been a busy and tiring week, but the result is that my bathroom is almost done! On Tuesday night, I got home from work and had dinner and then started to tackle the grout in the shower. Started at about 7. Had to run out between 8 and 9 to pick up more grout at Lowe’s, and didn’t pack it in until after midnight… and I still wasn’t done. I learned an important lesson: when you are grouting, work on only a small area at a time. If you leave the grout on for too long (more than about 15 minutes), it hardens and you have to scrape it off. That really sucks!

On Wednesday, Jim came and routed the floor and sanded the drywall. When I got home, I finished the shower and the primed and painted the walls where the toilet and vanity would go so that Jim could install them an Thursday. That all came together well.

IMAG1663

As of now, there are only a few things left to do: finish painting, touch up a few spots of grout, and caulk. Here are a couple of shots of the pretty new fixtures. They’re the Ashfield line by Pfister in Tuscan Bronze. I love the water pump-style handle! I promise more photos soon, when it is all done.
IMAG1664

IMAG1666

Also today, the Gord’s Basement Waterproofing guys were here for the second day digging down as far as the weeping tile on the side of the house to waterproof the house. Jim said that yesterday, they had to jackhammer down about 2 feet, because the ground was so frozen. They were finished by 2:45 this afternoon, and for the most part, you would not know they’d been here, they left it so neat. Now I’m confident that I can have the basement finished without worrying about dampness or leaks.

Ok, that’s it for now!

Can A Girl Get Some Insulation?

Hi friends! It’s been a little while since I’ve taken the time to post an update, so I will try to give you some of the highlights.

First, I can’t believe how poorly insulated this house is (and I dread the first gas bill!) I mentioned before that there was none downstairs – just paneling over cinder blocks, but upstairs, too! I took ripped out as much as I could of the kitchen last week, and the walls were plaster over this gypsum stuff, which is basically layers of compressed brown paper – like a thick cardboard box.

Layers
Layers

It had a foil back. And then there is a layer of tar paper on the block wall. Here’s a photo, after I ripped most of the wall out.
IMAG1654

I salvaged one upper and one base cabinet (after scrubbing it thoroughly – you can see how much mouse poo was beneath it) and have taken them downstairs for storage in the laundry room.
IMAG1650

I found some Melamine Paint at Home Depot, which I have always found to be the best product for cabinets, and I am going to paint them white, so that they match the washer and dryer.

I’m back to work now, so Jim does the work during the day (check out my beautiful shower) and I clean at night. IMAG1656
I swear, I have not done as much vacuuming and mopping floors in a lifetime as I have here! We’re constantly making messes and having to clean it up.

I have also hung new blinds in all of the bedrooms… got a great deal on Levolor blinds from Lowe’s, and had them delivered for free. Three blinds cost less than two would have elsewhere!

Finally, this weekend, my friend Shawn came over to help me out for a couple of hours. I was determined to do some major demo in the basement. I’d started to smash off the ugly bricks that were on the walls beside the fireplace, so by the time Shawn arrived the basement was covered in fine red dust. He helped finish removing them and then we ripped the paneling off of the rest of the basement. Shawn also removed the ugly 70s exterior lights that served to light up the “kitchen”, along with the range hood. He also disconnected the stove plug. Then he disconnected the water supply and cut the drainpipe and we pulled out the cabinet and got it into the dumpster. Here is the before and after.
IMAG1658 IMAG1660

The dumpster will be picked up tomorrow, and while it isn’t completely full, I now feel like we have filled it up enough to get it out of my driveway!

Since my last post, I had a birthday and celebrated with my friends, and then with my family. Thanks to all who joined! At the family get-together, I saw someone who was once a love interest… and it has been over 20 years since I’ve seen him. I was pretty speechless – and that happens almost never! He, of course, is married with children, but it was good to see him. 🙂

More soon.

Meet Stanley

Hey friends and family!  Welcome to the last day of 2014.  Yup, it is December 31st and it has been a busy and productive week.

Last post, I mentioned that I was heading downstairs to try to get the washing machine hooked up.  Well, a bit of advice – especially to you ladies: get a pipe wrench.  This is mine.

IMAG1634 It’s a Mastercraft (that’s a Canadian Tire brand) and I’ve had it for several years, and I couldn’t have connected the washing machine without it.  First, I needed it to turn off the water.  The round taps were so stiff that my little lady hands wouldn’t budge them.  This isn’t good when you’re trying to disconnect a hot water supply from an old washing machine!  I adjusted the wrench so that it was big enough to fit over the handle, and voila, it gave me plenty of leverage to turn the tap off.  I also had to use it to loosen the connection on the hose and tighten the new ones onto the new washing machine.  Done!  The unfortunate thing, which really bugs me, is that only while connecting the washing machine did I notice that it actually has a dent in the front.  Shame on Future Shop for delivering me a dented product.  Of course, you have to sign-off that the machine was delivered with no damage, which I did, but the laundry room is so poorly lit that I couldn’t see the dent.  It doesn’t impact the performance, though, so I’m just going to let it go.

Next in the update department – the stove plug.  This thing was a bit of a mess, but managed to chip out the tile to expose the metal plate for the outlet, undo a few screws, and rotate the outlet 180 degrees.  Then refastened the screws and done!  Made Christmas Eve dinner for my family that night!

On Boxing Day, I went with my friend Brandie to our friend Jimmy’s annual Boxing Day Blow-out.  Ok, it was less of a Blow-out/Drunk Fest this year, because 1) Jim moved to Burlington, so we can’t stumble home across the street anymore and 2) Brandie and I both had our family Christmas gatherings the next day.  We didn’t stay too late, but it sure was nice to see Jim’s new home, meet BabyMac and see Jim’s kids, Sarah, Wil and Andrew and our friend Shawn and his son Tyler and girlfriend Elora.  During the party, I firmed up plans with Jim for him to start working on my Bathroom Reno on Monday.

Here’s a picture of the bathroom before, when it was advertised in the Real Estate listing.  Tile from floor to ceiling, very dated turquoise fixtures, etc.  Definitely time for an overhaul.  I’m happy to jump in and do construction/lifting/tearing out, etc. but I won’t touch plumbing and I won’t touch electrical, so in this case I called in someone who can do it right.  Enter Jim.  And Stanley.  The Stanley FatMax 36″ Wrecking Bar.

IMAG1633

I’d been to Lowe’s on Sunday, and Stanley Fat Max tools were on for 25% off, so “Stanley” was only $15.  Worth every penny.  On Monday Jim and I set to tearing down the bathroom.  Here’s Stanley hard at work.  Yes, I know, the rear photo in the Yoga pants is regrettable, but let’s move past that… removing those tiles was much easier with a strong wrecking bar!  I also smashed my finger pretty good between the wall and Stanley, but it’s not broken.  After removing all of those bloody tiles (that’s a plaster wall) we had to put them into contractor garbage bags and take them out into my garage.  Thankfully I HAVE a garage.  Now I just need to arrange to have all that crap hauled away.

stanley_work

 

After day 1, we had the tub, plumbing, toilet and vanity removed and all of the wall tiles.  Day 2 was another adventure entirely: Even Stanley could not budge the floor tile, which was laid on top of about 2.5 inches of loose cement and wire mesh.  Jim had to bring in the power tools – a hammer drill – and basically chisel it out chunk by awful, heavy, nasty, dusty chunk.  The entire house was covered with a layer of dust afterwards.  Gross.  And once again, we had to pile it all into garbage bags and haul it out.  Which then makes me shudder at where all of that crap will go after it is dropped at the dump.  Land fill.  Terrible and wasteful.  It makes me want to use only wood in my house, so that at least it could be incinerated.  By the end of Day 2, it was looking much better.  Here are a few more photos.  Now, since it is New Year’s Eve, the work is on pause until Friday.  See you then.

Happy New Year!